Oce plotwave 345 User Manual

Move and re-adjust the printing system
Introduction
When you move the printing system to a new location, you must check if it needs re-adjustment
to ensure the best output quality.
You need two tools for the adjustment procedure. You can find these tools behind the lower right
front cover.
Required tools
Allen key and Key wrench
IMPORTANT
• When the printer is connected, you must first switch off and disconnect the printer (see
Turn
off the printing system on page 213 and Disconnect the network cable and the mains supply
cable on page 215).
• Close the media drawers.
NOTE
Be aware of the size of the printer working area (see
Working area (Footprint) on page 19).
Procedure
1.
Release the wheel brakes and move the printing system to its new location.
2.
When the system is at the right place, lock the brakes.
3.
Pull firmly to open the media drawer.
Move and re-adjust the printing system
216
Chapter 5 - Maintain the Printing System

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)