Oce plotwave 345 User Manual

Scan to a USB key
Introduction
When you insert a USB key in the user panel, you can scan to USB.
Before you begin
• Before you scan to USB, make sure the correct settings are enabled. For more information see,
Enable or disable USB on page 103.
• You can create a template with USB as destination to easily submit your job. For more
information, see Create a new template on page 96.
Procedure
1.
Feed the original face up and centered on the original feeding table.
2.
Insert a USB key into the USB port on the user panel.
The scan tile is automatically selected on the user panel. Select a template with USB as
destination or change the destination to USB.
3.
Tap the green button to start the scan job.
NOTE
Wait until the light in the USB port stops blinking, before you retract the USB key.
Result
A scan to file is made, and saved on your USB key. You can retrieve the file from your USB key.
Scan to a USB key
Chapter 4 - Use the Printing System
203

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)