Oce plotwave 345 User Manual

Set the alignment mode
Introduction
When you want to shift the image on the sheet, you can change the alignment mode. With the
alignment mode, you can also optimize the print productivity as you reduce the distance the print
carriage has to travel. You can, for instance, align the image to the top right-hand corner of the
sheet.
You can choose the following alignment settings:
Alignment mode
[Top left] [Top] [Top right]
[Left] [Center] [Right]
[Bottom left] [Bottom] [Bottom right]
Procedure
1.
Open the [Preferences] - [Print job defaults] tab.
2.
Click on [Edit] in the [Layout] section or click on the [Alignment] setting.
3.
Select the correct value.
Select [Top right] when the print productivity is the most important factor.
4.
Click [Ok] to confirm, or [Cancel] to reject your entries.
Set the alignment mode
130
Chapter 3 - Define your Workflow with Océ Express WebTools

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)