Oce plotwave 345 User Manual

Copy by set
Introduction
You can use the [Create set] option to make multiple scans and copy in one set.
Procedure
1.
Feed the original face up and centered on the original feeding table.
2.
Tap the copy tile. A window with a list of presets opens.
3.
In the job pane on the right, tap [Create set].
The green button changes color and displays [Add].
4.
Tap the green button to start scanning.
5.
When the printer releases the original, insert the next original.
6.
Tap the green button. The scan is added to the set.
Repeat this step until your set is complete.
7.
Tap the [Finish set] tile to finish the set.
Result
The printer copies the set of originals.
Copy by set
188
Chapter 4 - Use the Printing System

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)