Oce plotwave 345 User Manual

Introduction to license management
Introduction
For certain applications your printer uses, you need to activate a license. A product license for the
Océ PlotWave 345/365 is always required. You can perform several actions for licenses:
Procedure
1.
View the currently active licenses.
View which licenses you already have, and which you would like to have. You can make a list of
new options you need and note down the license number. Your local representative needs the list
of new options and the license number to create a new license file.
2.
Get the host ID of your system.
The host id is needed to create a new license file.
3.
Send the list of new options, the license number, and the host ID to your local representative.
Your local representative creates and delivers a new license file.
4.
Create a back-up of the currently active licenses, if necessary.
Save the current active licenses to do so.
5.
Activate the licenses.
The license activation job guides you through the following steps.
• 1. Locate the license file.
• 2. Preview the new active licenses.
• 3. Accept the end user license agreement.
• 4. Finish the license activation job.
• 5. Restart your system.
Introduction to license management
252
Chapter 6 - License Management

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)