Oce plotwave 345 User Manual

Set a default external location
Introduction
You can set an external location as the default location. The default location is used when you do
not select a specific external location for a job.
Procedure
1.
Select the [Configuration] - [External locations] tab.
2.
Under [External locations] select the external location you want to set as default.
3.
Click on the checkbox icon under [Actions].
Set a default external location
108
Chapter 3 - Define your Workflow with Océ Express WebTools

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)