Oce plotwave 345 User Manual

Save the settings in a file
Introduction
Save the settings and the values that you configured in Océ Express WebTools in a file.
Save the settings in a file to duplicate the settings very easily to another printer of the same type.
NOTE
Not all settings are stored in the settings file. The network settings are excluded from the file
because the network settings cannot be transferred to another printer. The passwords for
authorized users and the passwords for external locations are excluded from the file for security
reasons. License information is not included in the file either.
Procedure
1.
Open the [Configuration] tab or the [Preferences] tab.
2.
Click on [Save configuration] in the upper right-hand corner of the tab. A window opens.
3.
Navigate to a location on the network to store the file.
4.
Save the settings<hostname of printer><date>.xml file. The file name is not fixed. You can
change the name if required.
5.
Click [Ok] to confirm, or [Cancel] to close the window without storing the file.
Save the settings in a file
54
Chapter 3 - Define your Workflow with Océ Express WebTools

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)