Oce plotwave 345 User Manual

Make a copy and scale to another size
Introduction
When you want to scale your copy to another size, you can make changes under the advanced
settings. With the custom setting, you can choose any scale percentage you want between the
range of 10 - 1000%.
NOTE
For more information on the other scale modes, see
Preset category:Layout on page 170.
Procedure
1.
Feed the original face up and centered on the original feeding table.
2.
Tap the copy tile. A window with a list of presets opens.
3.
Tap [Show all settings]. A list with settings opens.
4.
Tap [Scale] under the [Layout] preset.
5.
Tap [Scale] in the new window and select [Custom].
6.
Under [Custom] select any percentage between 10 - 1000%.
7.
After you made your settings tap [OK].
8.
Enter the number of copies and tap the green button.
Make a copy and scale to another size
Chapter 4 - Use the Printing System
183

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)