Configure the media request time-out
Introduction
The user panel displays a message with a media request when the requested media is not
available on the printer.
• When the [Media request timeout] setting is disabled, the media request will be displayed on
the user panel until it is resolved.
• When the [Media request timeout] setting is enabled (default), you can enter a media request
time-out value in seconds. When the media request is not resolved within the media request
time-out period, the [Action after media request timeout] setting determines whether the
printer either deletes the job from the Job queue or puts the job in attention state.
Procedure
1.
Open the [Preferences] - [System defaults] tab.
2.
Click on [Edit] in the [Printer properties] section or click on the [Media request timeout] setting.
3.
When you enable the setting, you must enter a time period as well. If you choose to disable the
setting, the time period will not be adjustable.
4.
Click on the [Action after media request timeout] setting.
5.
Select [Put the job on attention state] or [Delete the job].
6.
Click on [Ok] to confirm or [Cancel] to reject your entries.
Configure the media request time-out
120
Chapter 3 - Define your Workflow with Océ Express WebTools
To Next Page
Loading...
