Oce plotwave 345 User Manual

Select the e-shredding algorithm
Introduction
The e-shredding function allows you to securely erase jobs from the system. This prevents
unauthorized people from accessing deleted jobs.
You can select one of the following algorithms:
• [Gutmann].
All jobs on the system are erased in 35 overwrite passes.
• [DoD 5220.22-M].
All jobs on the system are erased in three overwrite passes.
• [Custom] allows you to define the number of passes manually.
The factory default is [DoD 5220.22-M].
NOTE
Only set the number of overwrite passes to a number higher than 1 if your security policy
requires it. An increase of passes can affect the performance.
Procedure
1.
Open the [Security] - [Configuration] tab.
2.
Click on [Edit] in the upper right hand corner of the [E-shredding] section.
3.
Select the preferred method for the [E-shredding algorithm].
4.
Click OK to confirm.
Select the e-shredding algorithm
Chapter 3 - Define your Workflow with Océ Express WebTools
79

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)