Oce plotwave 345 - Set the Automatic Roll Switch

Set the automatic roll switch
Introduction
In Océ Express WebTools you can choose to enable or disable the [Automatic roll switch]. When
you enable the functionality and a specific roll has been selected, the printer automatically
continues printing on an (in size and type) identical roll. When you disable the functionality, the
printer stops and request to load a new roll of the same size and type in the same media drawer
location.
Procedure
1.
Open the [Preferences] - [System defaults] tab.
2.
Click on [Edit] in the [Printer properties] section or click on the [Automatic roll switch] setting.
3.
Select [Enabled] or [Disabled]. Select enabled if print productivity is an important factor.
4.
Click on [Ok] to confirm or [Cancel] to reject your entries.
Set the automatic roll switch
Chapter 3 - Define your Workflow with Océ Express WebTools
127