Oce plotwave 345 User Manual

How to solve problems with jobs
Procedure
1.
When there is a problem with a job, the color of the green job queue bar in Océ Express
WebTools turns red.
The system monitor section of Océ Express WebTools displays the message: [User intervention
required].
The job that has the problem remains in the queue as an active job, displayed in bold fonts.
2.
On the user panel detailed information about the problem is displayed. You can use this
information to solve the problem.
NOTE
If a media jam occurs often, you can perform the following checks:
- Is the media loaded correctly?
- Did you use the correct media? For more information, see Media on page 237
- Did you remove all the pieces of media from the paper path?
NOTE
If an error occurs that you cannot solve, please remember the error code displayed on
the user panel and contact the helpdesk for assistance.
How to solve problems with jobs
266
Chapter 8 - Solve Problems

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)