Oce plotwave 345 User Manual

Use LPR to send a print job
Introduction
The printer supports printing through LPR.
When you send your print job through LPR, the default Océ Express WebTools settings are
leading.
NOTE
You must enable printing through LPR in Océ Express WebTools.
How to send a print job via LPR
Type the following line command after the Command prompt: lpr -S <hostname or IP address> -P
<print queue name> <file name>.
NOTE
You can use any name for <print queue name>, for example jobs.
Use LPR to send a print job
Chapter 4 - Use the Printing System
153

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)