Oce plotwave 345 User Manual

Make a copy on a cut sheet
Introduction
You can copy on cut sheet media if the required media type or size is not available on the media
rolls of the printer.
Procedure
1.
Feed the original face up and centered on the original feeding table.
NOTE
The page orientation must be portrait.
2.
Tap the copy tile. A window with a list of presets opens.
3.
Tap [Show all settings]. A list with settings opens.
4.
Tap [Media source] under the [Media] preset.
5.
Tap [Media source] in the new window.
6.
Select [Manual] from the list of settings.
7.
Define the number of copies and tap the green button.
8.
Wait for the media request.
9.
Place the cut sheet media on the media bypass of the printer.
NOTE
Use the media size indication on the media bypass to align the cut sheet media
correctly. When you use a B1 media size (707 mm) you must align the cut sheet media
with the A1 indent.
Make a copy on a cut sheet
186
Chapter 4 - Use the Printing System

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)