Oce plotwave 345 - Make a Copy and Remove a Strip

Make a copy and remove a strip
Introduction
When you have an original with a strip, you can remove the strip from your copy.
Use the option on the user panel to copy an original with a strip, and remove the strip from the
copy. You can remove a strip from the top, the bottom, the left or the right side of the original.
NOTE
• For more information on the cut size settings, see
Preset category:Layout on page 170.
• You can also use this setting to copy a specific area of the original. For more information, see
Make a copy of a specific area of an original on page 181.
Procedure
1.
Feed the original face up and centered on the original feeding table.
2.
Tap the copy tile. A window with a list of presets opens.
3.
Tap [Show all settings]. A list with settings opens.
The [Top] strip
The [Bottom] strip The [Left] strip The [Right] strip
4.
Tap [Remove strip] under the [Layout] preset.
5.
Select [Top], [Bottom], [Left], or [Right] and define the values.
6.
Make your settings and tap [OK].
7.
Define the number of copies and tap the green button.
Make a copy and remove a strip
180
Chapter 4 - Use the Printing System