Oce plotwave 345 User Manual

Restore the factory defaults
Introduction
Sometimes you want to go back to the initial settings. You can restore the factory default settings
in Océ Express WebTools.
NOTE
Log in as a Key Operator to only restore the Key Operator settings. Log in as a System
Administrator to only restore the System Administrator settings. To restore all the factory
default settings you must log in as a Power User.
Procedure
1.
Open the [Configuration] tab, or the [Preferences] tab.
2.
Click on [Restore defaults] in the upper right-hand corner of the screen. A window opens.
3.
Click [Ok] to restore the factory default settings, or [Cancel] to close the window without restoring
the factory defaults.
Restore the factory defaults
56
Chapter 3 - Define your Workflow with Océ Express WebTools

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)