Optimise the print quality and print productivity
Set transparency flattening for PDF
Introduction
In Océ Express WebTools, you can select a setting to flatten transparency information in a PDF
document before printing. The setting is used for PDF documents containing transparency
information only.
You can choose between the following values:
• [Quality]
Select this value if print quality is an important factor. The processing speed slows down and
more memory is required.
• [Speed]
Select this value if PDF processing performance is more important than print quality. Large and
complex PDF files are processed faster and use less memory.
NOTE
You can only change the transparency flattening, when the [PDF render engine] setting is set to
[ Adobe PostScript interpreter ]. You can find this setting under [Preferences] - [Print job
defaults] - [PDF rasterization settings].
Procedure
1.
Open the [Preferences] - [Print job defaults] tab.
2.
Click on [Edit] in the [PDF rasterization settings] section or click on the [Transparency flattening]
setting.
3.
Select [Quality] or [Speed].
4.
Click [Ok] to confirm, or [Cancel] to reject your entry.
Optimise the print quality and print productivity
124
Chapter 3 - Define your Workflow with Océ Express WebTools
To Next Page
Loading...
Need help?
General
