Oce plotwave 345 User Manual

Refill the Toner
Refill the toner
Introduction
With the completely closed toner system, you can easily refill toner.
When to do
When a ‘Toner Low’ message appears on the user panel, you need to refill the toner. The
message will be displayed until you refill the toner. Under normal conditions the printer can
finish the current job, before it stops printing.
Before you begin
• You can leave the printer turned on when you refill the toner.
• Make sure you use toner suitable for the Océ PlotWave 345/365.
• You must use only one bottle of toner at a time. If you use more than one bottle, the
compartment will flood and toner will spill.
• When you have refilled the toner two consecutive times, you must also replace the residual
toner container. For more information, see Replace the residual toner container on page 244.
Refill the Toner
Chapter 5 - Maintain the Printing System
241

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)