Oce plotwave 345 User Manual

7.
Use both hands to slide the media under the metal paper guide (2) until the media is transported
automatically.
2
8.
If necessary, press the [clean cut button] to trim a strip of the new media roll. Press once for a
strip of approximately 20 cm (7.9 in) or hold the button and release it when the strip has the
desired length.
9.
Close the media drawer.
NOTE
Do not open the media drawer during loading.
10.
The user panel displays the message that new media is detected. Follow the steps in the wizard
to define the correct media type and size if not detected automatically.
Load a media roll (position 1)
232
Chapter 5 - Maintain the Printing System

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)