Setting the Output Conditions
218
ZW-7000/5000
User's Manual
Setting the Average Filter
Setting the Average Filter p.138
As an example, here is an explanation of the procedure for selecting the “128” average count setting.
Operating procedure
Steps Key operation Display Description
1 to 4 For moving to “FILTER”, see steps 1 to 4 on p.217.
5 Select “AVE” as the filter type.
Press the / keys to select “AVE” and press the
key.
6 Select the average count.
The current setting value is displayed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
In this example, select “128” and press the
key.
7 Press the key for two seconds to enter the RUN mode.
To Next Page
Loading...
