Omron ZW-7000 Series - Page 226

Setting the Output Conditions
224
ZW-7000/5000
User's Manual
Performing Thickness Scaling
Performing Thickness Scaling p.135
Operating procedure
Steps Key operation Display Description
1 to 5 For moving to “SCALE”, see steps 1 to 5 in p.221.
6 Select “THICK” as the scaling type.
The current setting value is displayed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
Select “THICK” and press the key.
7 The current measured value is displayed on the main display and the
current setting value is displayed on the sub-display.
Press key to enter the editing mode, and the sub-display
blinks.
To edit numerical values, use the / / / keys.
Enter the setting value and then press the
key.
8 “OK/CAN” is displayed on the sub-display.
Press the key to execute scaling or key to cancel.
9 Press the key for two seconds to enter the RUN mode.