Setting the Output Conditions
ZW-7000/5000
User's Manual
223
Sensor controller operations
7
Performing 2-point Scaling
Performing 2-point Scaling p.133
Operating procedure
Steps Key operation Display Description
1 to 6 For moving to “SCALE” - “AUTO”, see steps 1 to 6 in p.221.
7 Press the / keys to select “2PT” and press the key.
8 Press the key when the main display shows “POINT1”.
9 Set the measured value of point 1.
The current measured value is displayed on the main display and the
current
setting value is displayed on the sub-display.
To edit numerical values, use the / / / keys.
Enter the setting value and then press the key.
10 Press the key when the main display shows “POINT2”.
11 Set the measured value of point 2.
To edit numerical values, use the / / / keys.
Enter the setting value and then press the
key.
12 “OK/CAN” is displayed on the sub-display.
Press the key to execute scaling or
key to cancel.
13 Press the key for two seconds to enter the RUN mode.
To Next Page
Loading...
