Panasonic Micro-Imagechecker PV310 - Copying the Screen Display

304
Usin
g
a Com
p
act Flash Memor
y
Card
Cha
p
ter 13
13.4 Copying the Screen Display
You can copy the contents displayed on the entire screen following the steps below. As the data are saved as
bitmap, they can be edited on the computer. If the PV310 is in RUN mode, you can copy every screen display. If the
PV310 is in RUN and SETUP modes, you can copy almost every screen display.
1. Keep and hold down the B key for more than one second while the screen to be captured is
displayed.
The following messages appear below the status display area.
PRINT SCREEN
Now saving. Wait a minute.
When copying the screen display is completed, the message shown above disappears.
NO CF CARD
The PV310 does not recognize the Compact Flash memory card.
If this message appears, check if the Compact Flash memory card is properly inserted.
MEMORY USED UP. PRESS ANY KEY
If the following message shown below appeared, the Compact Flash memory card does not have enough
storage capacity to save the image. Use a Compact Flash memory card with sufficient storage capacity.
The image of the captured screen is saved in the following directory in a Compact Flash memory card:
Panasonic MEW Vision¥PV310¥Screen
The hardcopy function is available in the followings:
• READY signal is on in RUN mode
• In SETUP mode