63
Cha
ter 5
Procedure for Settin
Ins
ection Conditions
5.5 Importing Images into a Memory
This function can save an inspection object image data. Specify the positions, the area sizes and conditions of
the checker based on the image.
1. Press the B key while only the menu bar is displayed.
2. Highlight “Display Image”
3. Select “Live-C1”.
When the current image captured with the camera connected to the Camera 1 port is displayed, check the
followings:
• The desired object is focused.
• Position the object in the center and horizontal positions of the window as much as possible.
• Be sure to use the lighting that you are supposed to use for the actual inspection.
If you select “Live-C2” when two cameras are used for capturing the images, you should also check the
above.
4. Press the A key to capture the image.
To Next Page
Loading...
