Connect the connector of the fuel pump and the
piping acting on the quick-release fitting.
Connect the connector of the level indicator.
If required, correctly position the breather pipe by
following the steps below:
insert the transparent end of the breather pipe on
the appropriate tank fitting and tighten the retain-
ing clamp.
CAUTION
DURING INSTALLATION, MAKE SURE THAT THE PART
OF PIPE CONNECTED TO THE TANK IS THE CLEAR ONE.
Lay the pipe along the right side of the vehicle
making it adhere to the upper part of the fuel tank.
Chassis Beverly 300 i.e.
CHAS - 274
To Next Page
Loading...
