Chapter 5: Management with the CLU
175
Managing the Network Connection
The network connection deals with the VessRAID’s Management Port.
• Making Management Port Settings (below)
• Making iSCSI Port Settings (page 176)
Making Management Port Settings
When you log into the VessRAID over your network, you use the VessRAID’s
management port.
Before you change settings, please see “Choosing DHCP or a Static IP Address”
on page 28.
Making Automatic Settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight the management port and press Enter.
3. Highlight NetMgmt Ethernet Port Settings and press Enter
4. Highlight DHCP and press the spacebar to toggle to Enable.
5. Highlight TCP Port Number to change the entry.
3260 is the default and recommended for most applications.
6. Press Ctrl-A to save your settings.
Making Manual Settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight the management port and press Enter.
3. Highlight NetMgmt Ethernet Port Settings and press Enter
4. Highlight DHCP and press the spacebar to toggle to Disable.
5. Highlight each of the following and press the backspace key to erase the
current value, then type the new value.
• IP Address
• Subnet Mask
• Default Gateway IP Address
• DNS Server IP Address
6. Highlight TCP Port Number to change the entry.
3260 is the default and recommended for most applications.
7. Press Ctrl-A to save your settings.
To Next Page
Loading...
Need help?
General
