Chapter 4: Management with WebPAM PROe
67
Managing the Network Connection
The network connection deals with the VessRAID’s Management Port.
• Making Management Port Settings (below)
• Making iSCSI Port Settings (page 67)
Making Management Port Settings
When you log into WebPAM PROe over your network, you use the VessRAID’s
management port.
Before you change settings, please see “Choosing DHCP or a Static IP Address”
on page 28.
To make changes to the Management Port settings:
1. Click the Subsystem icon in Tree View.
2. Click the Administrative Tools icon.
3. Click the Network Management icon.
4. Click the Port Configuration link in Management View.
5. To enable DHCP, check the DHCP box.
When DHCP is NOT enabled, enter:
• Primary IP address
• Primary subnet mask
• Default gateway IP address
• Enter a primary DNS server IP address.
6. Enter a TCP port number.
3260 is the default and recommended for most applications.
7. Click the Submit button.
Making iSCSI Port Settings
VessRAID has four iSCSI ports. You must network settings to each iSCSI port
individually.
Before you change settings, please see “Choosing DHCP or a Static IP Address”
on page 28.
To make changes to the iSCSI Port settings:
1. Click the Subsystem icon in Tree View.
2. Click the Administrative Tools icon.
3. Click the Network Management icon.
To Next Page
Loading...
Need help?
General
