27
Chapter 3: VessRAID Setup
This chapter covers the following topics:
• Setting up the Serial Connection (below)
• Choosing DHCP or a Static IP Address (page 28)
• Setting up with the CLI (page 29)
• Setting up with the CLU (page 31)
• Setting up with the LCD (page 33)
• Creating Disk Arrays with WebPAM PROe (page 35)
Setting up the Serial Connection
VessRAID has a Command Line Interface (CLI) to manage all of its functions,
including customization. A subset of the CLI is the Command Line Utility (CLU), a
user-level interface that manages your VessRAID via your PC’s terminal
emulation program, such as Microsoft HyperTerminal. This procedure uses the
serial cable connection you made in Chapter 2, page 23.
You must use the CLI or CLU to assign an IP address to the VessRAID to enable
a network connection for WebPAM PROe.
1. Change your terminal emulation program settings to match the following
specifications:
• Bits per second: 115200
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: none
2. Start your PC’s terminal VT100 or ANSI emulation program.
3. Press Enter once to launch the CLI.
4. At the Login prompt, type administrator and press Enter.
5. At the Password prompt, type password and press Enter.
At this point, you are in the CLI. You can continue using the CLI to make
network settings or you can switch to the CLU. Go to:
• Setting up with the CLI (page 26)
• Setting up with the CLU (page 27)
To Next Page
Loading...
Need help?
General
