Chapter 5: Management with the CLU
209
Making Buzzer Settings
This function enables the buzzer on the controller. When you first power-up the
VessRAID, it beeps twice to show normal operation. To change buzzer settings:
1. From the Main Menu, highlight Buzzer and press Enter.
A list of Controllers appears with the current buzzer setting and status.
2. Highlight the Controller whose buzzer you want to set and press Enter.
3. Highlight Enabled and press the spacebar to toggle between Yes and No.
4. Press Ctrl-A to save your settings.
The buzzer provides the audible alarm. See “VessRAID is Beeping” on page 277.
To Next Page
Loading...