Chapter 4: Management with WebPAM PROe
83
Starting or Restarting Telnet service
To start or restart the Telnet service, click the Start or Restart button.
Making SNMP Settings
VessRAID’s SNMP service enables the SNMP browser to obtain information from
the VessRAID. The Trap Sink is where SNMP events are sent and can be
viewed.
To change the SNMP settings:
1. Click the Subsystem icon in Tree View.
2. Click the Administrative Tools icon.
3. Click the SNMP Management link in Management View.
4. Enter the SNMP Port number.
161 is the default.
5. Enter a System Name.
There is no default name.
6. Enter a System Location.
USA is the default.
7. Enter a System Contact (the email address of the administrator or other
individual).
8. Enter the Read Community.
Public is the default.
9. Enter the Write Community.
Private is the default.
To add a Trap Sink, see “Adding Trap Sinks” below.
10. Click OK in the confirmation box to restart the SNMP service with your
changes.
Adding Trap Sinks
To add a trap sink:
1. Enter a Trap Sink IP address.
2. Select a Trap Filter, choose the lowest level of Severity to be reported for
each event.
See “Setting-up User Event Subscriptions” on page 63 for an explanation of
the Severity levels.
3. Click the Update button.
The new trap sink appears in the Trap Sinks list.
To Next Page
Loading...
Need help?
General
