Chapter 5: Management with the CLU
199
6. Press Ctrl-A to save your settings.
To start, stop or restart the SNMP service, highlight Start, Stop, or Restart and
press Enter.
Managing SNMP Trap Sinks
Creating a SNMP trap sink
To create a trap sink:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight SNMP and press Enter.
4. Highlight Trap Sinks and press Enter.
A list of the current trap sinks appears.
Adding a trap sink
To add a trap sink:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight Create New Trap Sink and press Enter
4. Highlight Trap Sink IP address and press the backspace key to erase the
current value, then type the new IP address in this field.
5. Highlight Trap Filter and press the spacebar to toggle through the severity
levels.
The Severity Levels are (lowest to highest) Information, Warning, Minor,
Major, Critical and Fatal.
6. Press Ctrl-A to save the Trap Sink.
Deleting a trap sink
To delete a trap sink:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight the trap sink you want to delete and press the spacebar to mark it.
The mark is an asterisk (*) to the left of the listing.
4. Highlight Delete Marked Entries and press Enter.
To Next Page
Loading...
Need help?
General
