Chapter 5: Management with the CLU
197
Making SLP Settings
By default, SLP service is set to Automatic and its normal status is Started.
To make SLP service settings:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight SLP and press Enter.
4. Highlight Startup Type and press the spacebar to toggle between Automatic
and Manual.
5. Press Ctrl-A to save your settings.
To start, stop or restart the SLP service, highlight Start, Stop, or Restart and press
Enter.
Making Web Server Settings
By default, Web Server service is set to Automatic and its normal status is
Started.
To make Web Server service settings:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight Web Server and press Enter.
4. Highlight Startup Type and press the spacebar to toggle between Automatic
and Manual.
5. Highlight the following and press the backspace key to erase the current
value, then type the new value:
• HTTP Port (80 is the default)
• Session Time Out (24 minutes is the default. 1440 minutes = 24 hours)
6. Highlight SSL and press the spacebar to toggle between Enabled and
Disabled.
7. Highlight HTTPS Port and press the backspace key to erase the current
value, then type the new value. 443 is the default.
8. Press Ctrl-A to save your settings.
To start, stop or restart the Web Server service, highlight Start, Stop, or Restart
and press Enter.
To Next Page
Loading...
Need help?
General
