Chapter 9: Troubleshooting
289
Event Notification Response
When you choose Event Notification, WebPAM PROe sends popup and/or email
messages regarding its status. The messages you see depend on your
notification selection and what is currently happening in the VessRAID. See
“Setting-up User Event Subscriptions” on page 63.
The table below cites:
• Reported Events – Events that require you to take action
• Corrective Actions – The action you should take in response to the event
A list of event categories is shown below.
• Battery (page 289)
• Blowers (page 290)
• Cache (page 291)
• Controller (page 291)
• Disk Array (page 291)
• Drive Interface Controller
(page 292)
• Enclosure (page 292)
• Event Log (page 292)
• Host Interface Controller
(page 292)
• Logical Drive (page 293)
• Media Patrol (page 294)
• Online Capacity Expansion
(page 295)
• PDM (page 295)
• Physical Disk (page 296)
• PSU (Power Supply Units)
(page 297)
• RAID Level Migration (page 298)
• Rebuild (page 298)
• Redundancy Check (page 299)
• Resource (page 300)
• Spare Check (page 300)
• Spare Drives (page 300)
• SMART (page 300)
• Synchronization (page 300)
• System (VessRAID) (page 301)
• Transition (page 301)
• Watermark (page 301)
Reported Event Corrective Action
Battery
Battery temperature is
above the threshold
The battery is too hot. Verify proper airflow around
the through the VessRAID. If airflow is OK, replace
the battery. See page 240.
Battery temperature is
normal
Normal.
Battery capacity is below
the threshold
Battery is drained. Run battery reconditioning. See
page 103 (WebPAM PROe) or page 153 (CLU).
Battery capacity is normal Normal.
To Next Page
Loading...
Need help?
General
