VessRAID 1000i Series Product Manual
176
Making iSCSI Port Settings
VessRAID has four iSCSI ports. You must network settings to each iSCSI port
individually.
Before you change settings, please see “Choosing DHCP or a Static IP Address”
on page 28.
To make changes to the iSCSI Port settings:
Making Automatic Settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight the iSCSI port and press Enter.
3. Highlight NetMgmt iSCSI Port X Settings and press Enter
4. Highlight DHCP and press the spacebar to toggle to Enable.
5. Highlight TCP Port Number to change the entry.
3260 is the default and recommended for most applications.
6. Press Ctrl-A to save your settings.
Making Manual Settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight the management port and press Enter.
3. Highlight NetMgmt Ethernet Port Settings and press Enter
4. Highlight DHCP and press the spacebar to toggle to Disable.
5. Highlight each of the following and press the backspace key to erase the
current value, then type the new value.
• IP Address
• Subnet Mask
• Default Gateway IP Address
6. Highlight TCP Port Number to change the entry.
3260 is the default and recommended for most applications.
7. Press Ctrl-A to save your settings.
To Next Page
Loading...
Need help?
General
