Chapter 5: Management with the CLU
201
2. Highlight Software Management and press Enter.
1. Highlight the recipient whose settings you want to change and press Enter.
2. Type the recipient’s IP address into the field provided.
3. Highlight Message Event Severity Filter and press the spacebar to change
severity levels.
4. Press Ctrl-A to save your settings.
Deleting a Recipient
To delete a recipient:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight the recipient you want to delete and press the spacebar to mark it.
The mark is an asterisk (*) to the left of the listing
4. Highlight Delete Marked Entries and press Enter.
Netsend Requirements
In order to use Netsend:
• NetSend must be running the VessRAID
• You must provide the IP address for each recipient PC
• The Messenger service must be running on each recipient PC
If your Netsend and Messenger service settings are correct but the recipient PC
does not receive event messages, check the recipient PC’s Firewall settings.
Refer to your OS documentation for more information.
To Next Page
Loading...