This command is effective after 802.1X authentication.
802.1X re-authenticate only supports the message transmitting way of dot1x
eap-transfer.
【Example】
！Re-authenticate ethernet 0/5 in interface configuration mode
QTECH(config-if-ethernet-0/5)#dot1x re-authenticate
！Re-authenticate ethernet 0/5 globally
QTECH(config)#dot1x re-authenticate interface ethernet 0/5
8.3.8 dot1x re-authentication
Use dot1x re-authentication command to enable 802.1x re-authentication. Use no
dot1x re-authentication command to disable 802.1x re-authentication.
dot1x re-authentication
no dot1x re-authentication
【Default】
802.1X re-authentication disable
8-33
To Next Page
Loading...
