【Command configuration mode】
Interface configuration mode, global configuration mode
【Usage】
This command is effective after 802.1x authentication enables.
802.1X authentication only supports the message sending of dot1x eap-transfer.
【Example】
！Enable re-authentication of ethernet 0/5
QTECH(config-if-ethernet-0/5)#dot1x re-authentication
QTECH(config)#dot1x re-authentication interface ethernet 0/5
【Related command】
dot1x、dot1x eap-finish、dot1x eap-transfer
8.3.9 dot1x timeout re-authperiod
Use dot1x timeout re-authperiod command to configure 802.1x re-authperiod.
Use no dot1x timeout re-authperiod command to restore the default 802.1x
8-34
To Next Page
