R&S ZVB - Page 250

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT GUI Reference
Trace Menu
Operating Manual 1145.1084.12 – 30 235
Show Ripple Limits
Shows or hides the ripple limit lines associated with the active trace in a Cartesian diagram area. A
checkmark appears next to the menu item when the limit line is shown.
The vertical positions of the ripple lines are re-calculated after each sweep; only their stimulus range and
distance (the ripple limit) is fixed. The limit line colors are defined in the Define User Color Scheme dialog
(Display – Display Config. – Color Scheme...).
Display of the ripple limits and limit check are independent of each other: Hiding the limits does not
switch off the limit check.
Remote control:
CALCulate<Chn>:RIPPle:DISPlay[:STATe] ON | OFF
Ripple Check
Switches the ripple limit check of the active trace on or off. A checkmark appears next to the menu item
when the limit check is enabled.
When the limit check is switched on, an info field shows the pass/fail information and the measured ripple
in each ripple limit range, and a PASS or FAIL message for the entire active trace is displayed in the
center of the diagram. If the limit check fails in a particular ripple line range, the trace within the range can
change its color. The Limit Fail Trace color is defined in the Define User Color Scheme dialog (Display –
Display Config. – Color Scheme...). An acoustic signal (Global Beep) and a TTL signal indicating pass or
fail can be generated in addition.
Ripple limit check and display of the limit lines are independent of each other: With disabled limit
check, the limit line can still be displayed.
If no limit lines are defined for the active trace, the limit check can be switched on but will always PASS
the trace.
Remote control:
CALCulate<Chn>:RIPPle:STATe ON | OFF
CALCulate<Chn>:RIPPle:FAIL?
CALCulate<Chn>:RIPPle:SEGment<Seg>:STATe ON | OFF
CALCulate<Chn>:RIPPle:SEGment<Seg>:RESult?