Printer Service Mode
D117/D118 3-498 SM Appendix
1001 Bit Switch
bit 4
to 7
DFU
- -
1001 Bit Switch
009 Bit Switch 9 0 1
bit 0
PDL Auto Detection timeout of jobs
submitted via USB or Parallel Port (IEEE
1284).
0: Disable
(Immediately)
1: Enable
(10 seconds)
To be used if PDL auto-detection fails. A failure of PDL autodetection does
not necessarily mean that the job can not be printed. This bit switch tells the
device whether to time-out immediately (default) upon failure or to wait 10
seconds.
bit 1
DFU
- -
bit 2
Job Cancel
0: Disable
(Not
cancelld)
1: Enabled
(Cancelled)
Enable: All jobs will be cancelled after a jam occurs.
Note: If this bit switch is enabled, printing under the following conditions
might result in problems:
- Job submission via USB or parallel port
- Spool printing (WIM > Configuration > Device Settings > System)
bit 3
DFU
- -
bit 4
Timing of the PJL Status ReadBack (JOB
END) when printing multiple collated
copies.
0: Disable 1: Enable
To Next Page
Loading...
Need help?
General
