Ricoh GR-C1 User Manual

Main SP Tables-5
SM Appendix 3-337 D117/D118
Appendix:
SP Mode
Tables
009
RCG Write Timeout *CTL [0 to 100 / 60 / 1second/step]
Sets the length of time (seconds) for the time-out when sent data is written to
the RCG during a call over the @Remote network.
010
RCG Read Timeout *CTL [0 to 100 / 60 / 1second/step]
Sets the length of time (seconds) for the timeout when sent data is written
from the RCG during a call over the @Remote network.
011
Port 80 Enable *CTL
[0 or 1 / 0 / 1/step]
0: No. Access denied
1: Yes. Access granted.
Controls if permission is given to get access to the SOAP method over Port
80 on the @Remote network.
013
RFU Timing *CTL
[0 or 1 / 1 / 1/step]
0: Any status of a target machine
1: Sleep or panel off mode only
Selects the timing for the remote firmware updating.
014
RCG Error Cause CTL
[0 or 1 / 0 / 1/step]
0: Initial state, normal condition
1: Error
Displays RCG connection error. cause
021
RCG-C Registed *CTL
[0 or 1 / 0 / 1/step]
0: Installation not completed
1: Installation completed
This SP displays the RCG-N installation end flag.
023
Connect Type (N/M) *CTL
[0 or 1 / 0 / 1/step]
0: Internet connection
1: Dial-up connection
This SP displays and selects the RCG-N connection method.

Ricoh GR-C1 Specifications

General

Brand	Ricoh
Model	GR-C1
Category	All in One Printer
Language	English