FCU
D649 18 SM
The beeper sound is the same volume as the speaker sound.
The beeper sounds even if the sperker sound is turned off.
If the beeper does not sound, turn the main power switch on and off repeatedly and
do the transmission procedure 2 or 3 times.
If the beeper does not sound after turning the main switch on and off 3 times, you
need to input the settings stored in SRAM memory manually.
8. When “Ready” appears on the operation panel display, turn off the main power switch, and
then disconnect the flat flexible cable from the old FCU board.
9. Disconnect the flat flexible cable from the new FCU board.
10. Reassemble the machine (Attach the rear cover).
To Next Page
Loading...
Need help?
General
