Bit Switches
D649 74 SM
1
Action when the SAF memory
has become full during
scanning
0: The current page is erased.
1: The entire file is erased.
0: If the SAF memory becomes full during
scanning at the memory transmission, the
successfully scanned pages are transmitted.
1: If the SAF memory becomes full during
scanning at the memory transmission, the file
is erased and no pages are transmitted.
 This setting is effective only when
Automatic Journal printout is enabled
but the machine cannot print the report
(e.g., no paper).
2
RTI/CSI display priority
0: RTI 1: CSI
This bit determines which identifier, RTI or CSI,
is displayed on the LCD while the machine is
communicating in G3 non-standard mode.
3
File No. printing
0: Enabled
1: Disabled
1: File numbers are not printed on any reports.
NOTE: The file numbers may not be printed in
the sequential order. If a customer does not like
this numbering, select "0".
4
Action when authorized
reception is enabled but
authorized RTIs/CSIs are not
yet programmed
0: Faxes can be received if the
sender has an RTI or CSI
1: All fax reception is disabled
If authorized reception is enabled but the user
has stored no acceptable sender RTIs or CSIs,
the machine will not be able to receive any fax
messages.
If the customer wishes to receive messages
from any sender that includes an RTI or CSI,
and to block messages from senders that do
not include an RTI or CSI, change this bit to
"0", then enable Authorized Reception.
Otherwise, keep this bit at "1 (default setting)".
5-7 Not used Do not change the settings
To Next Page
Loading...
Need help?
General
