SC Tables
D117/D118 6-68 SM
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
877
CTL
B
SD card error
The 'all delete' function cannot be executed but DataOverwriteSecurity
Unit is installed and activated.
 Defective SD card
 SD card not installed
1. Replace the NVRAM and then install the new SD card.
2. Check and reinstall the SD card.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
878
-00
CTL
D
TPM system authentication error
The system firmware is not authenticated by TPM (security chip).
 Incorrect updating for the system firmware
 Defective flash ROM on the controller board
1. Replace the controller board.
-01 D
USB Flash Error
File system in the USB flash device is defective.
 Cannot mount partition 3 in the USB flash device.
 Encryption key does not exist.
 Cannot find the file for KMMD to be operated.
1. Replace the controller board.
-02 D
TPM Error
An error occurred in TPM or in TPM driver.
 TPM defective
1. Replace the controller board.
-03 D
TCSD Error
An error occurred in TPM software stack.
To Next Page
Loading...
Need help?
General
