Rohde & Schwarz SMBV100A - Page 718

Remote Control Commands
R&S
®
SMBV100A
703Operating Manual 1176.8016.02 ─ 17
Parameters:
<Stop> integer
Range: 0 to 8191
*RST: 0
Example:
BB:MCCW:EDIT:CARR:STOP 40
the carrier range stops at carrier 40.
Manual operation: See "Carrier Stop" on page 441
Trigger Settings
[:SOURce<hw>]:BB:MCCW:TRIGger:ARM:EXECute.........................................................703
[:SOURce<hw>]:BB:MCCW:TRIGger:EXECute.................................................................703
[:SOURce<hw>]:BB:MCCW:TRIGger:EXTernal:SYNChronize:OUTPut............................... 704
[:SOURce<hw>]:BB:MCCW:TRIGger:OBASeband:DELay................................................. 704
[:SOURce<hw>]:BB:MCCW:TRIGger:OBASeband:INHibit................................................. 705
[:SOURce<hw>]:BB:MCCW:TRIGger:RMODe?.................................................................705
[:SOURce<hw>]:BB:MCCW:TRIGger:SLENgth................................................................. 706
[:SOURce<hw>]:BB:MCCW:TRIGger:SOURce................................................................. 706
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:DELay.............................................706
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:INHibit.............................................707
[:SOURce<hw>]:BB:MCCW[:TRIGger]:SEQuence.............................................................707
[:SOURce<hw>]:BB:MCCW:TRIGger:ARM:EXECute
Stops signal generation for trigger modes Armed_Auto and Armed_Retrigger. A subse-
quent internal or external trigger event restart signal generation.
Example:
BB:MCCW:TRIG:SOUR INT
sets internal triggering.
BB:MCCW:TRIG:SEQ ARET
sets Armed_Retrigger mode, i.e. every trigger event causes sig-
nal generation to restart.
BB:MCCW:TRIG:EXEC
executes a trigger, signal generation is started.
BB:MCCW:TRIG:ARM:EXEC
signal generation is stopped.
BB:MCCW:TRIG:EXEC
executes a trigger, signal generation is started again.
Usage: Event
Manual operation: See "Arm" on page 445
[:SOURce<hw>]:BB:MCCW:TRIGger:EXECute
Executes a trigger. The internal trigger source must be selected using the command
MCCW:TRIGger:SOURce INTernal and a trigger mode other than AUTO must be
selected using the command :BB:MCCW:TRIGger:MODE.
SOURce Subsystem