Ross Vision - Transition Module; Fader

Ops 5–2 • Transitions Vision Operator’s Manual (v12.0 MD)
Transition Module
The Transition Module (Figure 5.1) allows you to set and perform all key and background
transitions on the assigned MLE or AuxKey. This includes the type of transition, as well as
whether the transition is a cut, auto-transition, or a manual transition using the fader.
The Transition Module is available in either a 2-Keyer version or a 4-Keyer version.
Figure 5.1 2-Keyer and 4-Keyer Transition Modules
Each Transition Module has a Fader for performing manual transition, a series of Next
Transition Select buttons, Transition Parameter buttons, Transition Type buttons, and two
Transition buttons.
Fader
The Fader (Figure 5.2) allows you to manually perform a wipe, dissolve, or Squeeze & Tease
transition by moving the fader handle from one limit to the other. The progress of the transition is
shown on the progress bar to the left of the fader handle. As you move the fader from one limit to
the other, the indicators light up, showing you how far through the transition you are.
Figure 5.2 Fader — Transition Module (4-Keyer Shown)
Aside from transitions, the fader can also be used to manually run a sequence. As with
performing a transition, the progress bar next to the fader handle lights up to show how far
through the sequence you are.
BKGD
T RANSITION
KEY 1 KEY 2
FRAMES
PST
BKGD
TRANS
PV
KEY
PRIOR
TRANS
LIMIT
DISS
ROLL
CLIP
WIPE DVE SEQ
CUT
AUTO
TRANS
BKGD
T RANSITION
KEY 1 KEY 2
FRAMES
PST
BKGD
TRANS
PV
KEY
PRIOR
TRANS
LIMIT
DISS
ROLL
CLIP
WIPE DVE SEQ
CUT
AUTO
TRANS
KEY 3 KEY 4
BKGD
T RANSITION
KEY 1 KEY 2
FRAMES
PST
BKGD
TRANS
PV
KEY
PRIOR
TRANS
LIMIT
DISS
ROLL
CLIP
WIPE DVE SEQ
CUT
AUTO
TRANS
KEY 3 KEY 4
BKGD
T
RAN
S
ITI
ON
KEY 1
K
EY
2
FRAMES
PS
T
BK
G
D
T
RAN
S
PV
KEY
P
RI
OR
TRAN
S
LIMIT
DI
SS
R
O
LL
C
LI
P
WIPE DVE
S
E
Q
CU
T
AU
T
O
TRAN
S
K
EY
3
K
EY
4