Vision Operator’s Manual (v12.0 MD) Squeeze & Tease Sequences and Wipes • Ops 15–9
Squeeze & Tease Wipes
A Squeeze & Tease Wipe is a Sequence that performs a transition, either on a background or
keyer. To create a wipe, you must first create a sequence that will take a key, with one or multiple
channels, through the required effect and end with it off-screen, or not visible in some other way.
Squeeze & Tease wipes can either be created from sequences, or you can use one of the
pre-created sequences and wipes provided with your switcher software. The sequences and wipes
are pre-installed when you purchase a new switcher.
To load new sequences unto your switcher, you must copy the wipes from the CD to a USB flash
drive. Then you recall the sequences on your Vision control panel.
For More Information...
• on the pre-created sequences and wipes, refer to the section “Squeeze & Tease MD
Wipes and Sequences” on page Ops 18-2.
• on recalling sequences from a USB flash drive, refer to the section “Storing and
Recalling Files and Setups” on page Eng 13-4.
• on storing and recalling sequences, refer to the section “Saving and Loading Sequences
and Wipes” on page Ops 15-10.
• on using a sequence or wipe, refer to the section “Using Squeeze & Tease MD Wipes
and Sequences” on page Ops 15-13.
To Next Page
Loading...
