Ops 4–44 • Switcher Basics Vision Operator’s Manual (v12.0 MD)
Copy Squeeze & Tease Channels
The Squeeze & Tease channel copy function allows you to copy the contents of a Squeeze &
Tease channel from one channel to another within the same keyer. You cannot copy a Squeeze &
Tease channel from one keyer to a channel in another keyer.
Use the following procedure to copy a Squeeze & Tease channel in the same keyer:
1. Press the SEL button on the Keyers Module for the Keyer that you want to copy the
Squeeze & Tease channel for. The S&T MD Position/Crop Menu 1-2 is displayed. The
key must already be flying.
2. Toggle Channel on the S&T MD Position/Crop Menu 1-2 to select the Squeeze &
Tease channel that you want to copy from.
3. Press and hold the PST PATT button on the Keyers Module.
Operating Tip — Instead of the PST PATT button, you can use the SEL button on the
Keyers Module for the Keyer that you want to copy the Squeeze & Tease channel for.
4. Press the KEYX button on the Transition Module for the keyer that you are copying the
Squeeze & Tease channel in.
This completes the procedure for copying a Squeeze & Tease channel in the same keyer.
To Next Page
Loading...
