Ops 9–16 • Still-Store Vision Operator’s Manual (v12.0 MD)
Creating and Renaming Directories
Still-Store images are stored in directories on the hard drive of the switcher. Directories can be
created and renamed as required.
Use the following procedure to create or rename a directory:
1. Navigate to the Still-Store Menu as follows:
• Press HOME B Effects B Still Store.
2. Press Select/Manage on the Still-Store Menu 1-2.
3. Create a directory as follows:
•Use the Contents knob on the Select Still Menu 1-2 to select the directory in
which you want to create a sub-directory. Directories are indicated by a slash (/) at
the end of the name.
• Press Create Directory on the Select Still Menu 1-2.
Create Directory Menu
Operating Tip — Refer to the section “Using the Naming Menus” on page Eng 5-16 for
more information on using the Create Directory Menu to enter a name.
• Enter the name for the directory you want to create in the New Name field. The
name can be no more than 8 characters in length.
• Press Accept New Name on the Create Directory Menu to create the directory.
4. Rename a directory as follows:
•Use the Contents knob on the Select Still Menu 1-2 to select the directory that
you want to rename. Directories are indicated by a slash (/) at the end of the name.
• Press Rename on the Select Still Menu 1-2.
• Enter the name for the directory you want to create in the New Name field. The
name can be no more than 8 characters in length.
• Press Accept New Name on the Rename File or Directory Menu to rename the
directory.
This completes the procedure for creating or renaming a directory.
Deleting Stills or Directories
Any still-store image, or empty still-store directory, on the switcher can be deleted. Only an
empty directory can be deleted. You must delete or move the still-store images from a directory
before you can delete it.
To Next Page
Loading...
