Ops 6–8 • Wipes, Patterns, Washes, and Mattes Vision Operator’s Manual (v12.0 MD)
4. Use the Size knob on the Pattern Parameters Menu 1-2, or the positioner, to adjust the
size of the pattern. The positioner is also used to adjust the position of the pattern.
5. Select a matte or wash color for the border as follows:
• Press Border Matte on the Pattern Parameters Menu 1-2.
• Select the Matte or Wash 1/2 generator you want to assign to the border.
• Press Modify Color or Modify Wash on the Mattes Selection Menu to adjust the
color of the border. Refer to the section “Washes and Mattes” on page Ops 6-11 for
information on selecting a color for a matte or wash.
This completes the procedure for adjusting the border and softness of a pattern.
Horizontal and Vertical Multiplication
The Horizontal and Vertical Multiplication features allow you to multiply the current pattern up
to 5 times both horizontally and vertically. For example, if you select the circle pattern and apply
5 horizontal and vertical multiples, there will be 5 circles across the screen by 5 down.
• Horizontal Multiplication — Press H-Mult on the Pattern Parameters Menu 1-2 until
the required number of multiples is reached. A maximum of 5 multiples can be used.
• Vertical Multiplication — Press V-Mult on the Pattern Parameters Menu 1-2 until the
required number of multiples is reached. A maximum of 5 multiples can be used.
Horizontal and Vertical Multiplication — Pattern Parameters Menu 1-2
To Next Page
Loading...
