Ops 17–28 • WARP Effects Vision Operator’s Manual (v12.0 MD)
Sand WARP
The Sand WARP creates an effect that looks like a sand storm removing the key to reveal the
background. The effect can progress from left to right, or right to left.
Use the following procedure to set up a Sand WARP:
1. Select and activate the Sand WARP effect on the keyer you want to apply it.
2. Press Sand on the S&T WARP Menu.
Sand (Sand) — S&T WARP Menu
3. Adjust the sand of the effect as follows:
•Use the Direction knob on the S&T WARP Menu to select the direction that the
effect will progress in.
•Use the Opacity knob on the S&T WARP Menu, or the positioner, to adjust the
opacity of the grains of sand.
•Use the Progression knob on the S&T WARP Menu, or the positioner, to adjust
the position of the trailing edge of the effect.
4. Adjust the wind effect as follows:
• Press Wind on the S&T WARP Menu.
Sand (Wind) — S&T WARP Menu
•Use the Oscillation knob on the S&T WARP Menu, or the positioner, to adjust
the oscillation in the sand. Changing this in a sequence creates the illusion of
movement in the sand.
•Use the Velocity knob on the S&T WARP Menu, or the positioner, to adjust the
perceived velocity of the wind.
To Next Page
Loading...
